Contromax Product Manual
CtrlK
  • CONTROMAX Manual Site
    • ICD & Manual
      • ServoMax 12
        • 1. Introduction
        • 2. Electrical Interface
        • 3. Introduction to CAN Protocol
        • 4. User Configuration Parameter
        • 5. Position Control Parameter
        • 6. Parameter Description
        • 7. Appendix
      • All Other Series
        • 1. Basic Operation
        • 2. CAN Specification
        • 3. Electrical Interface
        • 4. CAN Message Exchange Architecture
        • 5. Operation Command & Response Message
        • 6. PBIT(Powerup Built In Test) Details and Demonstration
        • 7. Memory Access Message
        • 8. Reference
    • ServoMax Engine
      • Getting Started
        • Install
        • Config Files
        • GUI at a glance
      • Setting
        • Set kVaser, USB CAN Module
        • Configuration
          • General
            • Motor Off Mapping
            • Tx and Save Rate
          • AutoRun
          • Function Setting
      • Operation
        • CAN Control
  • Basics
    • Editor
    • Markdown
    • Images & media
    • Interactive blocks
    • OpenAPI
    • Integrations
Powered by GitBook
On this page
  1. CONTROMAX Manual Site
  2. ICD & Manual

All Other Series

Rev.F

Disclaimer

(a) This product may malfunction if tampered with by the user, potentially causing direct or indirect harm. Please exercise caution during use.

(b) Users should thoroughly test the ServoMax in its standalone state before integrating it into the final application.

Previous7. AppendixNext1. Basic Operation

Last updated 2 days ago